Spare
parts (NEW) |
Features |
Price
excluding P&P
Delivery time |
Partially complete frame sets
|
Frame sets, not 100% complete |
|
TYNE Sports Double 17ft 2 - Set 1
Photo coming soon
|
We have most of the frame parts to complete almost a full set. A build will be done shortly to determine completeness for this particular frame set. All new parts as from the original factory. Any frame parts that we may be short of, we can make.
If you have a good condition Tyne Sports Double 17 skin, but the frame mostly needs replacing, then this set would do !
Do contact us ASAP and we will do a complete build to check on completeness and take photos
|
£r
Up to
1 week |
TYNE Sports Double 17Ft 2 - Set 2
Photo coming soon
|
We have most of the frame parts to complete almost a full set. A build will be done shortly to determine completeness for this particular frame set. All new parts
If you have a good condition Tyne Sports Double 17 skin, but the frame partially needs replacing, then we would build up a set!
Bulk ordering of frame parts will work out cheaper than buying a few individual parts
|
£r
Up to
1 week |
Universal frame parts
|
Parts that are standard for most of the TYNE models |
|
TYNE Seat bottom - board only
|
Shaped plywood seat board without the base. Varnished
Sold in singles
|
£10.00
Up to
1 week |
TYNE Seat bottom - complete
Photo coming soon
|
Complete seat bottom. Varnished. |
£
Up to
1 week |
TYNE back rest (Short)
|
Short backrest with width of 38cm (Right hand in photo)
Complete with brass fitting on the ends for the brass securing bolts
Excludes securing brass bolts / wing nuts
|
£15.00
Up to
1 week |
TYNE backrest (Long)
|
Long backrest with width of 46cm (Left hand in photo)
Complete with brass fittings on the ends for the brass securing bolts
Excludes securing brass bolts / wing nuts
|
£15.00
Up to 1 week
|
TYNE Front cockpit "nose"
|
Triangular nose piece for front of cockpit. Complete with V brass sides.
Excludes mast hole - can be cut on request
Excludes securing brass bolt / wing nut - can be supplied / fitted at extra cost |
£10.00
Up to 1 week |
TYNE Rudder unit
|
Rear Rudder unit complete with rudder blade, cross piece and rudder pin - excludes rudder pedals, rudders bars |
£
Up to 1 week |
TYNE Longitudinal frame pieces
|
Floor keel board ladders, side pole / gunwale stringers, cockpit washboard / coaming |
|
|
Tyne Sports Double 17 - Front half (Black) section - for reference only |
|
|
Tyne Sports Double 17 - Rear half (Red) section. For reference only |
|
|
Tyne Sports Double 17 - Cockpit section |
|
TYNE Floor ladder - Bow (SD17) |
For TYNE Sports Double (17ft 2)
Length = |
|
TYNE
floor ladder - Front centre (SD17) |
For TYNE Sports Double (17ft 2)
Length = |
|
TYNE floor ladder - Rear centre (SD17) |
For TYNE Sports Double (17ft 2)
Length = |
|
TYNE floor ladder - Stern (SD17) |
For TYNE Sports Double (17ft 2)
Length = |
|
TYNE Floor ladder - Bow / Stern(?) 86cm
|
For TYNE ?
Length =
86cm |
|
TYNE
floor ladder - Centre (?) 78cm
|
For TYNE ?
Length = 78cm |
|
TYNE floor ladder - Centre (?) 76cm
|
For TYNE ?
Length = 76cm |
|
TYNE floor ladder - Stern (?) |
For TYNE ?
Length = |
|
TYNE Pole stringer, round - Bow / Black (?) |
For TYNE ?
Attaches to the Bow end post. Complete with brass fittings on both ends (flat strip and ferrule)
Length = |
|
TYNE
Pole stringer, round - Front centre (?) |
For TYNE ?
For centre section. Complete with male brass ferrules on both ends
Length = |
|
TYNE Pole stringer, round - Rear centre
|
For Tyne Sports Double 17 ft 2
For centre rear section (Red). Complete with male brass ferrules on both ends. One male ferrule is longer to accommodate sliding ferrule (not included)
Dia = 15mm
Length = 137cm |
|
TYNE Pole stringer, round - Stern / Red (?) |
For TYNE ?
Attaches to the Bow end post. Complete with brass fittings on both ends
(flat strip and ferrule)
Length = |
|
TYNE Upper gunwale stringer, half round, Stern / Red - 100cm (?)
|
For Tyne Sports Double 17 ft 2
Red. Attaches to the end post. Complete with brass and alu fittings on both ends
Length = 100cm, including alu and brass end fittings
|
|
TYNE Upper gunwale stringer, half round, black - 133cm (?)
|
For Tyne Sports Double 17 ft 2
Red. Attaches to the end post. Complete with brass and alu fittings on both ends
Length = 133cm, including alu and brass end fittings
|
|
TYNE Pole stringer, half round - CR (?) |
|
|
TYNE Pole stringer, half round - Stern (?) |
|
|
TYNE Pole stringer, half round - |
For TYNE ?
Raw wood - unvarnished, with no aluminum fittings
Length = |
|
TYNE Washboard, Front left, 141cm
|
For Tyne Sports Double 17 ft 2
Front Port washboard / coaming
Length = 141cm
|
|
TYNE Washboard, Front left with brass, 141cm
|
For Tyne Sports Double 17 ft 2
Front Port washboard / coaming with brass plate
Length of wood = 141cm
|
|
TYNE Washboard, Front right, 141cm
|
For Tyne Sports Double 17 ft 2
Front Starboard washboard / coaming
Length = 141cm
|
|
TYNE Washboard, Rear Port, 130cm
|
For Tyne Sports Double 17 ft 2
Rear Port washboard / coaming
Length = 130cm, including rear brass fitting
|
|
TYNE Washboard, Rear Starboard, 130cm (?)
|
For Tyne Sports Double 17 ft 2
Rear Starboard washboard / coaming
Length = 130cm, including brass fitting
|
|
TYNE End post, Bow (?) |
|
|
TYNE End post, Bow (?) |
|
|
TYNE End post, Stern (?) |
|
|
TYNE End post, Stern (?) |
|
|
TYNE Cross frame pieces |
Cross ribs, rear cockpit washboards |
|
TYNE Cross rib #1 (SD17)
|
Cross rib #1 - Tyne Sports Double 17 ft 2
Latter single piece plywood design. Brass fittings for sides and bottom can be fitted / supplied |
£25.00 |
TYNE Cross rib #2 (SD17)
|
Cross rib #2 - Tyne Sports Double 17 ft 2
Latter single piece plywood design. Brass fittings for sides and bottom can be fitted / supplied |
£30.00 |
TYNE Cross rib #3 (SD17)
Photo coming soon
|
Cross rib #3 - Tyne Sports Double 17 ft 2
Latter single piece plywood design. Brass fittings for sides and bottom can be fitted / supplied |
£30.00 |
TYNE Cross rib #4 (SD17)
|
Cross rib #4 - Tyne Sports Double 17 ft 2
Latter single piece plywood design. Brass fittings for sides and bottom can be fitted / supplied |
£30.00 |
TYNE Cross rib #5 (SD17)
|
Cross rib #6 - Tyne Sports Double 17 ft 2
Latter single piece plywood design. Brass fittings for sides and bottom can be fitted / supplied |
£30.00 |
TYNE Cross rib #6 (SD17)
Photo coming soon
|
Cross rib #6 - Tyne Sports Double 17 ft 2
Latter single piece plywood design. Brass fittings for sides and bottom can be fitted / supplied |
<£25.00 |
TYNE Cross rib #1 (11.5)
|
Cross rib 1 - Tyne Short Single (Prefect) 11ft 5
Latter single piece plywood design. Brass fittings for gunwale stringers can be fitted / supplied |
£25.00 |
TYNE Cross rib #2 (11.5)
|
Cross rib #2 - Tyne Short Single (Prefect) 11ft 5
Latter single piece plywood design. Brass fittings for gunwale stringers can be fitted / supplied |
£30.00 |
TYNE Cross rib #3 (11.5)
|
Cross rib #3 - Tyne Short Single (Prefect) 11ft 5
Latter single piece plywood design. Brass fittings for gunwale stringers can be fitted / supplied |
£30.00 |
TYNE Cross rib #3 (11.5) with backrest
|
Cross rib #3 with fixed backrest - Tyne Short Single (Prefect) 11ft 5
Latter single piece plywood design. Brass fittings for gunwale stringers can be fitted / supplied
|
£35.00 |
TYNE Cross rib #4 (11.5)
|
Cross rib #4 - Tyne Short Single (Prefect) 11ft 5
Latter single piece plywood design. Complete with brass fittings |
£25.00 |
TYNE back washboard
|
Back washboard - 39cm |
£10.00 |
TYNE |
|
|
TYNE Metal hardware |
Standard hardware for all TYNE models |
|
TYNE Alu rudder hanger bracket
|
Cast aluminum rudder hanger bracket |
£20.00 |
TYNE Alu bow end protector cap
|
|
£20.00 |
TYNE Alu hook
|
|
£10.00 |
TYNE Alu rudder blade holder
|
|
£25.00 |
TYNE Alu rudder horns / cross bar
|
|
£30.00 |
TYNE Brass ferrule, short male
|
Brass ferrules, male, short. For pole stringers |
£4.00 |
TYNE Brass ferrule, long male
|
Brass ferrules, male, long. For Red pole stringers - sliding ferrule end |
£4.50 |
TYNE Brass ferrule, female |
|
|
TYNE Brass securing bracket, large
|
|
|
TYNE Brass backrest securing bracket, small
|
For backrests |
|
TYNE Brass washboard plates
|
Brass plates for joining washboard frame pieces |
|
TYNE Brass cross rib / washboard fastener
|
Attaches to the horns of the cockpit cross ribs. Hammerhead bolts goes through and locks onto the "head". |
£3.00 |
TYNE Brass pin long, keel-board
|
|
|
TYNE Brass pin short , keel-board
|
|
|
TYNE Brass washboard hammerhead bolt
|
|
£4
.00 |
TYNE |
|
|
TYNE |
|
|
TYNE |
|
|
TYNE Miscellaneous |
Miscellaneous for all TYNE models |
|
TYNE Stainless flag pole
(photo taken in poor light!)
|
|
|
|
|
|
Spare
parts (USED) |
Features |
Price
excluding P&P
Delivery time |
TYNE complete frame sets - Used
|
Various TYNE models - listed when in stock |
|
TYNE ??
|
Awaiting inventory checks, etc
|
£r
Up to
1 week |
TYNE ??
|
Awaiting inventory checks, etc
|
£r
Up to
1 week |
TYNE various bits and pieces - Used
|
Miscellaneous - listed when in stock |
|
TYNE ??
|
Awaiting inventory
|
£r
Up to
1 week |
TYNE ??
|
Awaiting inventory
|
£r
Up to
1 week |